Page 1 of 1
10" matter control touch mount?
Posted: Thu Apr 28, 2016 11:00 pm
by Qdeathstar
Good news is I had a very nice print of the mount of the 7" tablet for matter control touch. The bad news is I have the 10" mount.
My question is is there a 10" mount available or is it time to break out inventor and make my own? I'd rather not spend the time....
Re: 10" matter control touch mount?
Posted: Sat Apr 30, 2016 9:56 am
by Eaglezsoar
I also have searched for this mount and have not found one in Thingiverse or our repables files except for this one:
http://repables.com/r/497/
Re: 10" matter control touch mount?
Posted: Sun May 01, 2016 1:39 am
by Qdeathstar
Actually just designed one before going out of down. Needs a bit of tweeting but it was surprisingly close. Just a bit small.
I'll have to see if it's my printer calibration or model when I get back into town, fix it, then I'll post it. Seems like matter hackers isn't making the 7" anymore.
Re: 10" matter control touch mount?
Posted: Mon May 02, 2016 8:53 am
by bernards
Eaglezsoar wrote:I also have searched for this mount and have not found one in Thingiverse or our repables files except for this one:
http://repables.com/r/497/
This one will block the camera of the 10". That is if you use the camera.