Good news is I had a very nice print of the mount of the 7" tablet for matter control touch. The bad news is I have the 10" mount.
My question is is there a 10" mount available or is it time to break out inventor and make my own? I'd rather not spend the time....
10" matter control touch mount?
-
Qdeathstar
- Printmaster!
- Posts: 622
- Joined: Wed Apr 13, 2016 7:42 pm
-
Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7185
- Joined: Sun Apr 01, 2012 5:26 pm
Re: 10" matter control touch mount?
I also have searched for this mount and have not found one in Thingiverse or our repables files except for this one: http://repables.com/r/497/
“ Do Not Regret Growing Older. It is a Privilege Denied to Many. ”
-
Qdeathstar
- Printmaster!
- Posts: 622
- Joined: Wed Apr 13, 2016 7:42 pm
Re: 10" matter control touch mount?
Actually just designed one before going out of down. Needs a bit of tweeting but it was surprisingly close. Just a bit small.
I'll have to see if it's my printer calibration or model when I get back into town, fix it, then I'll post it. Seems like matter hackers isn't making the 7" anymore.
I'll have to see if it's my printer calibration or model when I get back into town, fix it, then I'll post it. Seems like matter hackers isn't making the 7" anymore.
Re: 10" matter control touch mount?
This one will block the camera of the 10". That is if you use the camera.Eaglezsoar wrote:I also have searched for this mount and have not found one in Thingiverse or our repables files except for this one: http://repables.com/r/497/