Different auto calibration?

[Nxt-1]

I fairly new to 3D printing and I'm still trying to understand the whole thing, calibration in particular (magic seems to be involved). In effort to trying to understand this I am wondering what the difference is between sending G29 for autocalibration form a terminal and selecting full autocalibration from the lcd menu.

[Dale Eason]

From the code I can find there is no difference. The command from the LCD ends up sending A G29 to the gcode processor.
Dale

[pouncingiguana]

What Dale said. Didn't see the point in implementing two different calibration routines. Everything plays nice with the same setup.