Bondtech Extruder Problems

A place to talk about user-made mods and upgrades to their machines
Post Reply
Northspire
Prints-a-lot
Posts: 23
Joined: Wed Apr 20, 2016 9:24 pm
Location: Western North Carolina

Bondtech Extruder Problems

Post by Northspire »

I finally managed to get back to working on my rostock v2 and the extruder is acting weird.

Here is how the filament starts out.
[img]http://i.imgur.com/dziq7sHundefined.jpg[/img]
Here is how it ends up after a few minutes and it stops feeding.
[img]http://i.imgur.com/tx0ygGpundefined.jpg[/img]

Any Ideas? I believe it has something to do with the amount of pressure building up in the hot end.
It extrudes fine to start with and as it goes it extrudes less and less until it just chews up the filament and stops extruding
Here is my config.g file
config.zip
(1.66 KiB) Downloaded 212 times



Edit to clarify and add config file
Machines:
Rostock V2 Meanwell SP 750-24 Power Supply,710n Nano W/l Router,E3D Chimera Hot-End,713 Maker Effector and Hot-End Mount,Duet 0.8.5,Bondtech QR Extruder,PanelDue W/ 7 Inch T/S,Mini IR Height Sensor,24V Heated Bed With SSR,46 Quart Dry Box.
Post Reply

Return to “Mods and Upgrades”