Anyone have a good guide for wiring the H1 with a Sanguino...? or a solid build log ? Even photos?
Thanks in advance...!
-SD
Sanguino Build Instructions or Log?
- michaellatif
- Printmaster!
- Posts: 357
- Joined: Mon Mar 26, 2012 1:34 pm
- Location: RTP, NC
Re: Sanguino Build Instructions or Log?
I think as long as you follow the build instructions for the board you have and use the wiring instructions for the H-1 you have enough information to get it put together.
If you are looking for what wire to what pin, there is quite a bit of information on the RepRap wiki for your board, for example Sanguinololu:
http://reprap.org/wiki/Sanguinololu
For wiring schematics:
http://reprap.org/wiki/Sanguinololu#Wiring_shematics
For H-1 electronics manual:
http://forum.seemecnc.com/viewtopic.php?f=39&t=69
Then I have a thread in this forum for settings used with Repetier Host/Firmware.
http://forum.seemecnc.com/viewtopic.php?f=31&t=33
Let me know if you are looking for something else.
If you are looking for what wire to what pin, there is quite a bit of information on the RepRap wiki for your board, for example Sanguinololu:
http://reprap.org/wiki/Sanguinololu
For wiring schematics:
http://reprap.org/wiki/Sanguinololu#Wiring_shematics
For H-1 electronics manual:
http://forum.seemecnc.com/viewtopic.php?f=39&t=69
Then I have a thread in this forum for settings used with Repetier Host/Firmware.
http://forum.seemecnc.com/viewtopic.php?f=31&t=33
Let me know if you are looking for something else.
Mike Latif
H-1 #3
H-1 #3
Re: Sanguino Build Instructions or Log?
I think I have the boot loader on my board but I need to get the firmware loaded now... I am trying to figure all this out but everything is so vague.
Re: Sanguino Build Instructions or Log?
Ah, welcome to the world of open source!
Sublime Layers - my blog on Musings and Experiments in 3D Printing Technology and Art
Start Here:
A Strategy for Successful (and Great) Prints
Strategies for Resolving Print Artifacts
The Eclectic Angler
- michaellatif
- Printmaster!
- Posts: 357
- Joined: Mon Mar 26, 2012 1:34 pm
- Location: RTP, NC
Re: Sanguino Build Instructions or Log?
What board are you using and what firmware?solodude wrote:I think I have the boot loader on my board but I need to get the firmware loaded now... I am trying to figure all this out but everything is so vague.
Mike Latif
H-1 #3
H-1 #3