I recently picked up a Prusa i3 kit for $300 (new including shipping). After getting it working and even printing well but for the past few days I'm having intermittent issues and I'm trying to determine if it is the power supply (12v) or the controller board (MKS Base v1.3).
I removed the PSU and tested the voltage at the AC input and the three DC outputs but they were all as expected.
So now I'm trying to think how to check the PSU again while it's under a load of some kind.
I don't have any good ideas on how to do this, I have a few strips of 12v LED lights but I'm not sure that would put enough on it.
Any suggestions other than hooking up the printer and running it?
How to Load Test a 12 or 24v PSU
- briankb
- Printmaster!
- Posts: 106
- Joined: Thu Jun 13, 2013 11:50 am
- Location: North Florida - USA
- Contact:
How to Load Test a 12 or 24v PSU
- CNC's: Rostock Max upgraded to v3.2, Prusa i3 MK3 MMU, Formlabs Form SLA, Shapeoko3 CNC, Palette+, Palette 2 Pro
- Software: Fusion 360, SpaceClaim Engineer, Simplify3D, Repetier Firmware & Host, VCarve Pro
- Software: Fusion 360, SpaceClaim Engineer, Simplify3D, Repetier Firmware & Host, VCarve Pro
Re: How to Load Test a 12 or 24v PSU
Don't you have a heated bed on the printer? If not, get one and test the voltage while it's heating the bed.
g.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
- briankb
- Printmaster!
- Posts: 106
- Joined: Thu Jun 13, 2013 11:50 am
- Location: North Florida - USA
- Contact:
Re: How to Load Test a 12 or 24v PSU
Indeed and I have an extra one, wish I had just thought of that... thanks!
- CNC's: Rostock Max upgraded to v3.2, Prusa i3 MK3 MMU, Formlabs Form SLA, Shapeoko3 CNC, Palette+, Palette 2 Pro
- Software: Fusion 360, SpaceClaim Engineer, Simplify3D, Repetier Firmware & Host, VCarve Pro
- Software: Fusion 360, SpaceClaim Engineer, Simplify3D, Repetier Firmware & Host, VCarve Pro
-
- Printmaster!
- Posts: 44
- Joined: Sat Aug 29, 2015 9:04 pm
Re: How to Load Test a 12 or 24v PSU
I have the same problem it's the MKS v1.3 board.