Rostock v3 vs Rostock v3.2
-
- Plasticator
- Posts: 8
- Joined: Thu Jul 22, 2021 11:53 am
Rostock v3 vs Rostock v3.2
Hello. I am trying to start printing on my Rostock v3. I went to the quick start guide and the only instructions that I could find were for the Rostock v3.2. I was told that they were the same but when I started looking at the instructions they were not consistent with my printer. I seem to have an older version. which brings me to the question if there is a difference between the two? If so, could someone please send me the proper configuration instructions for the Rostock v3? it would be much appreciated as I have looked everywhere. Thank you.
Re: Rostock v3 vs Rostock v3.2
They're nearly identical mechanically, but vastly different electronically.
g.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Re: Rostock v3 vs Rostock v3.2
All of the Rostock MAX v3 manuals can be found here: https://www.seemecnc.com/pages/downloads - scroll down down to "Rostock MAX v3".
g.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects