extruder steps per mm settings?

Talk about KISSlicer software here (http://kisslicer.com)
Post Reply
User avatar
cristin
Plasticator
Posts: 10
Joined: Mon Jun 08, 2015 1:27 pm

extruder steps per mm settings?

Post by cristin »

Hi there,

I was looking through the KISSlicer docs last night, and while the docs showed a place in the extruder settings for mm/rev, it wasn't there in my settings (latest stable on the mac)

is the documentation only for v1.5 and above? as I'm having issues getting enough material out on the first layer, lots of thin lines that aren't quite merging.
modded rostock max v2
driving it via astroprint.
User avatar
Tincho85
Printmaster!
Posts: 659
Joined: Sun Nov 03, 2013 12:27 pm
Location: Buenos Aires, Argentina

Re: extruder steps per mm settings?

Post by Tincho85 »

How I did it:
[youtube]http://www.youtube.com/watch?v=1GyiivRWzHc[/youtube]

Or you can check Triffid Hunter's calibration guide:
http://reprap.org/wiki/Triffid_Hunter%2 ... tion_Guide
Martín S.
User avatar
Tincho85
Printmaster!
Posts: 659
Joined: Sun Nov 03, 2013 12:27 pm
Location: Buenos Aires, Argentina

Re: extruder steps per mm settings?

Post by Tincho85 »

Oh you don;t know where it is, not how to calibrate it... well my bad.
Hope it helps someone else :D
Martín S.
User avatar
cristin
Plasticator
Posts: 10
Joined: Mon Jun 08, 2015 1:27 pm

Re: extruder steps per mm settings?

Post by cristin »

I'll try installing the latest beta tonight and see if that fixes it.
modded rostock max v2
driving it via astroprint.
Post Reply

Return to “KISSlicer”