I downloaded Kisslicer and have been trying to familiarize myself with it. I have wanted a few videos read the setup ect. I'm rocking the Rostock Max V2. I supported the Diamond 3 in one printer on kickstarter and I would like to have Kisslicer homed in and ready to print by the time it gets here( A FEW MONTHS!!! )) So on that note My Kisslicer didn't start on the bed of the machine. What settings did I mess up???
Thank you,
Ziggey
KISSlicer
-
- Printmaster!
- Posts: 458
- Joined: Sun Sep 07, 2014 2:39 am
Re: KISSlicer
Ziggey wrote:I downloaded Kisslicer and have been trying to familiarize myself with it. I have wanted a few videos read the setup ect. I'm rocking the Rostock Max V2. I supported the Diamond 3 in one printer on kickstarter and I would like to have Kisslicer homed in and ready to print by the time it gets here( A FEW MONTHS!!! )) So on that note My Kisslicer didn't start on the bed of the machine. What settings did I mess up???
Thank you,
Ziggey
Suggest starting from mhackney's very good initial configuration files in the KISSlicer sub-forum.
"Trust no quote from the Internet." - Abraham Lincoln
Re: KISSlicer
Moved to the Kiss topic...
Your issue is vague. It sounds more like you have not set Z=0 correctly rather than a slicer issue.
Your issue is vague. It sounds more like you have not set Z=0 correctly rather than a slicer issue.
Sublime Layers - my blog on Musings and Experiments in 3D Printing Technology and Art
Start Here:
A Strategy for Successful (and Great) Prints
Strategies for Resolving Print Artifacts
The Eclectic Angler