Enclosure for the V4

This is where you can discuss the RostockMAX v4!
Post Reply
conrad404
Noob
Posts: 1
Joined: Sun Aug 11, 2019 9:48 am

Enclosure for the V4

Post by conrad404 »

So I have had some really good results with my Rostock V4 all it needed was an enclosure for better ABS results. Soon I will experiment with nylon.

I posted the files and my terrible instructions on thingiverse for all to use.
The enclosure does not interfere with the print head or the glass holding clamps.

https://www.thingiverse.com/thing:3787990

I have to thank SEEMECNC for posting the cad files for the base and top online. It was nice being able to import them into fusion 360 and drawing my design around them, it saved me so much measuring then trial and error.
Attachments
enclosure open.jpg
clearence.jpg
enclosure.jpg
geneb
ULTIMATE 3D JEDI
Posts: 5238
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Enclosure for the V4

Post by geneb »

Nicely done!

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Ramrodzergy
Noob
Posts: 3
Joined: Mon Apr 20, 2020 1:26 pm

Re: Enclosure for the V4

Post by Ramrodzergy »

Thanks for posting this I printed the top and bottom in PETG and going to use reflective bubble wrap so I can print a new design in ABS ( I found the CAD files you mentioned) My design is going to be a little bit wider and use the edges for support. Also I plan on adding chamber thermal regulation to it and possibly a heater if the chamber needs it.
Post Reply

Return to “RostockMAX v4”