hello,
I want to calibrate and level the bed on printer ROSTOCK MAX V3.2
the seemecnc manual that I used for the update said not to use G29 run mash and I cannot see the bed map.
Page 12 said to do some configuration on the config file, but I don't know the parameters...
also, I have a z probe problem G32 Error: Z probe readings not consistent.
there is no mesh compensation in the plugins
m115
FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 3.4.4 ELECTRONICS: Duet WiFi 1.02 or later FIRMWARE_DATE: 2022-10-20 16:17:41
I used this manual https://docs.google.com/document/d/1IQf ... 7U9pw/edit
page 14: "At the web browser control “Dashboard”, select “Delta Calibration” from the drop down menu “Compensation & Calibration” (do not run “Mesh”)"
I can not see my bed level...
thank you.
bed leveling after Firmware Upgrade v3.4.4
Re: bed leveling after Firmware Upgrade v3.4.4
What parameters do you need?
g.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Re: bed leveling after Firmware Upgrade v3.4.4
I thought the dimension of Rosrock V3.2 but it's working ok
I used this guide to update https://docs.google.com/document/d/1IQf ... 7U9pw/edit
my problem now is the G29 Error: Z probe readings are not consistent
when I do calibration...
do I need to change something in the config file?
post that I asked about it in duet3d forum
https://forum.duet3d.com/topic/34345/bed-level/5
thank you!
I used this guide to update https://docs.google.com/document/d/1IQf ... 7U9pw/edit
my problem now is the G29 Error: Z probe readings are not consistent
when I do calibration...
do I need to change something in the config file?
post that I asked about it in duet3d forum
https://forum.duet3d.com/topic/34345/bed-level/5
thank you!
Re: bed leveling after Firmware Upgrade v3.4.4
You'll get that if the heat bed is on during probing or if the nozzle is dirty.
g.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects