Hello All,
Has anyone installed the Zesty Nimble in the RailcoreII 300ZL?
I made a lg Delta printer with E3D V6 and the Nimble and the results are very good.
I thought the light extruder weight and remote extruder stepped would be a good fit for the RailcoreII.
/quadcells
Zesty Nimble
-
- Plasticator
- Posts: 12
- Joined: Tue Feb 06, 2018 6:53 pm
Re: Zesty Nimble
Give it a shot and let us know how you like it! Sounds like it could be awesome. Don't forget that if you haven't already purchased the parts, these awesome folks have roped Project R3D into offering a kit now!
Also, I imagine most folks working on these outfits are going to be heading over to the new forum at forum.railcore.org
Also, I imagine most folks working on these outfits are going to be heading over to the new forum at forum.railcore.org
Re: Zesty Nimble
Hello,
Yea I will ask the guys over at Zesty Nimble for their advice on the mount for it.
I already ordered most of the parts and I did see that they have kits now.
Thanks for the railcore forum site.
/quadcells
Yea I will ask the guys over at Zesty Nimble for their advice on the mount for it.
I already ordered most of the parts and I did see that they have kits now.
Thanks for the railcore forum site.
/quadcells
Re: Zesty Nimble
I registered over there but still not activated. Does it take a while?RanchRifle wrote: Also, I imagine most folks working on these outfits are going to be heading over to the new forum at forum.railcore.org
-
- Plasticator
- Posts: 12
- Joined: Tue Feb 06, 2018 6:53 pm
Re: Zesty Nimble
I doubt it is automated. May have to wake him up?
Re: Zesty Nimble
The activation email was in my spam folder.