Zesty Nimble

Post Reply
quadcells
Plasticator
Posts: 5
Joined: Fri Feb 09, 2018 10:15 am

Zesty Nimble

Post by quadcells »

Hello All,
Has anyone installed the Zesty Nimble in the RailcoreII 300ZL?
I made a lg Delta printer with E3D V6 and the Nimble and the results are very good.
I thought the light extruder weight and remote extruder stepped would be a good fit for the RailcoreII.

/quadcells
RanchRifle
Plasticator
Posts: 12
Joined: Tue Feb 06, 2018 6:53 pm

Re: Zesty Nimble

Post by RanchRifle »

Give it a shot and let us know how you like it! Sounds like it could be awesome. Don't forget that if you haven't already purchased the parts, these awesome folks have roped Project R3D into offering a kit now!

Also, I imagine most folks working on these outfits are going to be heading over to the new forum at forum.railcore.org
quadcells
Plasticator
Posts: 5
Joined: Fri Feb 09, 2018 10:15 am

Re: Zesty Nimble

Post by quadcells »

Hello,
Yea I will ask the guys over at Zesty Nimble for their advice on the mount for it.
I already ordered most of the parts and I did see that they have kits now.
Thanks for the railcore forum site.
/quadcells
quadcells
Plasticator
Posts: 5
Joined: Fri Feb 09, 2018 10:15 am

Re: Zesty Nimble

Post by quadcells »

RanchRifle wrote: Also, I imagine most folks working on these outfits are going to be heading over to the new forum at forum.railcore.org
I registered over there but still not activated. Does it take a while?
RanchRifle
Plasticator
Posts: 12
Joined: Tue Feb 06, 2018 6:53 pm

Re: Zesty Nimble

Post by RanchRifle »

I doubt it is automated. May have to wake him up?
quadcells
Plasticator
Posts: 5
Joined: Fri Feb 09, 2018 10:15 am

Re: Zesty Nimble

Post by quadcells »

The activation email was in my spam folder.
Post Reply

Return to “RailCore”