Hey Guys,
I have an Artemis and also have an Ultimaker S5.
As far as I can tell the only way to do dual extrusion on the Artemis is to clean install Cura 4.6.2 (this seems to be the latest version that the 3mf profile batarang imports into without having issues switching filaments upon execution)
Clean installing however involves uninstalling other versions of Cura.
My Ultimaker needs the latest version to run with the latest Firmware.
Is there a clever way to run 2 instances of Cura and preserve my Dual Extrusion ability for my Artemis? Anyone had success with the Artemis Dual Extrusion and running a Non-cura based slicer?
Any direction would be great.
DR
Question about Cura 4.6.2
Re: Question about Cura 4.6.2
This might help you out: https://github.com/seemecnc/slicing-pro ... Cura%204-6
While the profiles are for 4.6, there's some dual extrusion ".curaprofile" files in there that may help.
g.
While the profiles are for 4.6, there's some dual extrusion ".curaprofile" files in there that may help.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects