Page 1 of 1

XY dimensions are incorrect

Posted: Sat Mar 21, 2020 6:54 pm
by felich
Is there a way to calibrate the XY dimensions?
Cura shows the correct dimensions but the print comes out shorter in both x and y directions.
Any ideas?

Re: XY dimensions are incorrect

Posted: Sun Mar 22, 2020 12:48 pm
by geneb
Shorter by how much?

g.

Re: XY dimensions are incorrect

Posted: Fri Aug 14, 2020 8:45 am
by dc42
If the scaling is consistent, you can use a M579 command in config.g to correct for small scaling errors. To check the scaling is consistent, print a large noughts-and-crosses/tic-tak-toe pattern on the bed, and check that the lines are straight.