Is there a way to calibrate the XY dimensions?
Cura shows the correct dimensions but the print comes out shorter in both x and y directions.
Any ideas?
XY dimensions are incorrect
Re: XY dimensions are incorrect
Shorter by how much?
g.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Re: XY dimensions are incorrect
If the scaling is consistent, you can use a M579 command in config.g to correct for small scaling errors. To check the scaling is consistent, print a large noughts-and-crosses/tic-tak-toe pattern on the bed, and check that the lines are straight.