Screaming Demon

[KB9AVO]

No No No ... nothing about bearings ... mine are just great ... The Artemis is just doing great prints, and now added the dual color option..

I know Part Daddy and the crew are running hard, so looking at the online group that may have created a video on the making of a 2 color part and how to get the CURA setup for it. AND how to know which feeder is #1 or #2
I THINK I had it setup .. but still only runs 1 color, so I know I messed up some where..
The guide should be step by step,
Thanks all

Paul

[AlanZ]

If yours was one of the first batches of Artemis (that have the FSR in the base) make sure you have the most current firmware... the original firmware gave all sorts of odd issues.