Fix for your v3 calibrating.
Posted: Thu Dec 03, 2020 5:11 pm
So I had an issue with my v3’s calibration. Long story short, I hit the wrong button, it lost its mind, and just rammed itself into the Z tower or bed when i tried to do a full calibration. This fixed it, literally copy and paste this Into your G code editor, load it to your SD card and hit go.
M502
G4 S2
M500
G4 S2
Once this is done power cycle the machine. After that go back and do a full calibration and your done. I hope this helps anyone with similar issues.
M502
G4 S2
M500
G4 S2
Once this is done power cycle the machine. After that go back and do a full calibration and your done. I hope this helps anyone with similar issues.