- duet 0.8.5
e3d v6 24v
24V 350W power supply
Injection Molded Cheapskates
Tricklaser carbon fiber arms
Heat sinks on all of the stepper motors
I'm going to use the 24v power supply hooked directly to the duet. I plan on putting a fuse inline from the duet to the heated bed, I'm guessing ~20A car fuse should work.
After reading and re-reading what I think are all of the posts about using 24V I'm still concerned about thermistors and LED's on the onyx bed. I've read where these should be updated but I haven't been able to find any specific info, such as what resistor to use on the LED or a specific thermistor to use. If someone could point me in the right direction I would appreciate it.