Search found 554 matches
- Wed Jun 05, 2013 9:20 pm
- Forum: The Build Zone
- Topic: Default Rostock
- Replies: 69
- Views: 43590
Re: Default Rostock
I just finished building it (except the control panel mount), and I plugged it in and got it set up with the ports and stuff. I can monitor the temperature of the heated be and hot end, but nothing else seems to do anything. I can't move the stepper motors or actually heat up the bed or hot end. My ...
- Tue Jun 04, 2013 10:45 pm
- Forum: The Build Zone
- Topic: Default Rostock
- Replies: 69
- Views: 43590
Re: Default Rostock
Hey I just noticed that on some of the laser engraved parts, the engraved lines are cut more than half way through the melamine. It looks like they were vector cut instead of rastered. Are they supposed to be like that? It seems like such deep cuts would seriously mess with the strength of the ...
- Tue Jun 04, 2013 3:20 pm
- Forum: The Build Zone
- Topic: Default Rostock
- Replies: 69
- Views: 43590
Re: Default Rostock
OK another dumb question. The heated bed power wire needs to be 14 gauge according to the manual. Is 14 gauge wire included with the kit? If not, can I just twist a few wires together from the included grey cable?
- Mon Jun 03, 2013 7:11 pm
- Forum: The Build Zone
- Topic: Default Rostock
- Replies: 69
- Views: 43590
Default Rostock
Hi everyone, I've been stalking you all for the last few months to get a good understanding of the Rostock. I just got mine on May 31st, and now I have almost all of the mechanical stuff assembled (except the hot end and heated bed). So the first problem I've run into is that the power supply doesn ...