Search found 27 matches

by DITAmech01
Sat May 02, 2015 1:04 pm
Forum: New Member introduction
Topic: Hello from Snohomish WA
Replies: 1
Views: 1825

Hello from Snohomish WA

Hello! New Max V2 owner in WA state, north of Seattle. Owned a Printrbot a couple of years ago, learned a lot, sold it after a few months - tired of continuous calibration. Past few months, my 16-y.o. son started using SolidWorks as part of his robotics club, and we talked about getting another 3D ...
by DITAmech01
Sat May 02, 2015 1:00 pm
Forum: Troubleshooting
Topic: PEEK fan installation causes temp error on Max v2?
Replies: 5
Views: 5157

PEEK fan installation causes temp error on Max v2?

Hello! I'm almost done with assembling/calibrating my new Max V2 and I've hit a weird snag. I successfully printed the two fan shrouds and installed them. First time turning on power, the PEEK fan turned on immediately, which shouldn't happen - hot end wasn't turned on yet. Printer display and ...

Go to advanced search