Search found 4 matches

by dnvm84
Sat Dec 22, 2018 2:14 am
Forum: Rostock MAX v2
Topic: Max V2 Calibration Help
Replies: 7
Views: 1925

Re: Max V2 Calibration Help

Hello, Joe actually they are in place but I did not try the endstop screws because as I stated in my first post they were not long enough to work. So instead of trying them again just to find out that they would not work I just went with the endstop offset. As far as I can tell they do the same thin...
by dnvm84
Fri Dec 21, 2018 5:32 pm
Forum: Rostock MAX v2
Topic: Max V2 Calibration Help
Replies: 7
Views: 1925

Re: Max V2 Calibration Help

Hello, thank you DeltaCon for the information. So I took the rods to work and started doing some detail measuring. The difference between the longest rod and the shortest rod was .068 inches. So I modified all of the rods to match the shortest rod. All of the rods are within .001 inch except for one...
by dnvm84
Thu Dec 20, 2018 10:34 pm
Forum: Rostock MAX v2
Topic: Max V2 Calibration Help
Replies: 7
Views: 1925

Re: Max V2 Calibration Help

Hello, thank you Joe for your reply. I actually have the Assembly Guide 4th edition and the Users Guide 1st edition which is what I was using to do the calibration procedure. But here is my issue ( Sorry I should have included this on the first post): When I run the script my X,Y, and Z heights are ...
by dnvm84
Tue Dec 18, 2018 7:58 pm
Forum: Rostock MAX v2
Topic: Max V2 Calibration Help
Replies: 7
Views: 1925

Max V2 Calibration Help

Hello, I purchased a Max V2 (early version, ATX Power supply) from a coworker who bought it from a another person who setup the unit. My coworker brought the unit to work for me to inspect. Unfortunately I messed up the Z origin causing the head to crash into the table. Being that I never worked wit...

Go to advanced search