Search found 3 matches
- Wed Apr 11, 2018 8:46 pm
- Forum: General Tips 'N Tricks
- Topic: Need a little color (paint) on your prints?
- Replies: 0
- Views: 2705
Need a little color (paint) on your prints?
Do you need to add a little paint (color) to your prints? I tried nail polish but it didn't work very well. this did.... https://www.ebay.com/itm/PAINT-MARKERS-OIL-BASED-SET-OF-12-COLORS-FINE-OIL-BASED-ART-PEN-SIPA-NEW/331920549010?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649 They ...
- Mon Apr 02, 2018 5:20 pm
- Forum: Troubleshooting
- Topic: Cura 3.2.1 printer selection for Rostock V3.2
- Replies: 3
- Views: 2901
Re: Cura 3.2.1 printer selection for Rostock V3.2
Thanks you SO much for the Cura printer configuration info for Rostock 3.2. Now, I have Mattercontrol AND CURA slicing away.
- Sun Apr 01, 2018 10:20 pm
- Forum: Troubleshooting
- Topic: Cura 3.2.1 printer selection for Rostock V3.2
- Replies: 3
- Views: 2901
Cura 3.2.1 printer selection for Rostock V3.2
I just printed my first 3DBenchy with Gcode. Next step, I want to use a slicing software. I chose/downloaded Cura 3.2 and the install was full of problems. I finally managed Cura to load and now, I need to select my printer. I DON"T SEE my Rostock V3.2 or any of SeeMeCNC models at all. I guess ...