Search found 6 matches
- Tue Jan 17, 2017 4:07 pm
- Forum: Troubleshooting
- Topic: I could use some purchase advice/help.
- Replies: 15
- Views: 10519
Re: I could use some purchase advice/help.
Thanks everyone for all the input, it's helped a lot. I'm positive I'll be getting a delta in the near future, the V3 is one my top contenders, I was almost positive it was the right one for me, but I've found I need to do a bit more research before I make an investment. Thanks again every one, very...
- Sun Jan 15, 2017 5:54 pm
- Forum: Troubleshooting
- Topic: I could use some purchase advice/help.
- Replies: 15
- Views: 10519
Re: I could use some purchase advice/help.
I wouldn't recommend trying to build with a different controller, unless you have a really good idea what you are doing. Setting up the electronics and the firmware is the area most people seem to run into issues, while I agree the Duet is a better solution that the RAMBO, expecting a new builder t...
- Sat Jan 14, 2017 11:42 pm
- Forum: Troubleshooting
- Topic: I could use some purchase advice/help.
- Replies: 15
- Views: 10519
Re: I could use some purchase advice/help.
Duet electronics replaces the rambo. It is responsible for interpreting the gcode and translating that into moving the steppers, extruder, and hotend/bed temps. It also does everything that the raspberri pi would do running octoprint. The pi allows you to control the printer wirelessly. The duet al...
- Sat Jan 14, 2017 8:20 pm
- Forum: Troubleshooting
- Topic: I could use some purchase advice/help.
- Replies: 15
- Views: 10519
Re: I could use some purchase advice/help.
1: You can do better on amazon visavi the raspberry pi.... it's also not a necessary upgrade and maybe i'd spend my money elsewhere. For example, duet electronics from the start is a good upgrade to do from the start. 1. Ok, but still, what does a raspberry pi do with the rostock? 1.1 What are duet...
- Sat Jan 14, 2017 5:13 pm
- Forum: Troubleshooting
- Topic: I could use some purchase advice/help.
- Replies: 15
- Views: 10519
I could use some purchase advice/help.
I'm interested in the Rostock Max V3. I have a few questions, as this would be my first 3d printer. 1. The raspberry Pi option What does it do/ what functionality would I gain? The $50 "add Raspi" option when ordering, is that much different than the $70 Raspi in the parts section? What's ...
- Sat Dec 31, 2016 1:57 am
- Forum: Members Marketplace
- Topic: Rostock Max V2 For Sale
- Replies: 18
- Views: 12111
Re: Rostock Max V2 For Sale
Hello, I'm possible interested in your printer.
Would it be possible to contact you via email or phone?
I'm in BC, couple hours outside of Vancouver.
Would it be possible to contact you via email or phone?
I'm in BC, couple hours outside of Vancouver.