Welcome to the SeeMeCNC Community

Use a heater cartridge and screw in thermistor, much better than the stock setup. http://www.ebay.com/itm/Modular-Screw-on-M3-Stud-Thermistor-for-Reprap-Prusa-3D-Printer-Hot-End-Hotend-/321341736569" onclick="window.open(this.href);return false; http://www.ebay.com/itm/111252607429?_trksi...

Thanks for posting the information above http://forum.seemecnc.com/memberlist.php?mode=viewprofile&u=4354 , I used your step by step instructions, and it homed correctly the first time after I uploaded the firmware that I downloaded from the HE280 product page. However, NOW it will not display t...

I am having problems with the new HE280, and customer support tells me it is the result of the machine not recognizing the accellerometer. I upgraded my old(er) Orion hotend, arms, wire harness, and shuttles..and the software (as far as I have gotten so far) cannot be loaded in a way that the machin...

I am having very similar issues on an Orion. I upgraded my old(er) Orion hotend, arms, wire harness, and shuttles..and the software (as far as I have gotten so far) cannot be loaded in a way that the machine knows which way is up! The calibration fails every time I upload the recent builds of the EE...

Hey, is there an update on this? I upgraded my old(er) Orion and the software is cannot (as far as I have gotten so far) cannot be loaded in a way that the machine knows which way is up! The calibration fails every time U upload the recent builds of the EEPROM firmware. When I load the 2015 build, t...

By saying: "You could reset the z height in the EEPROM ( it's probably showing a weird number) to approximately the right value and the go ahead and then calibrate the z height normally." You are saying that I should re-send the Repetier config file back to EEPROM? My menu selection on the...