Search found 6 matches

by MrBaz
Fri Jan 27, 2017 10:36 pm
Forum: The Lounge
Topic: Direct Drive E3D Titan?
Replies: 5
Views: 2802

Re: Direct Drive E3D Titan?

by MrBaz
Fri Jan 27, 2017 10:35 pm
Forum: The Lounge
Topic: Infrared cameras?
Replies: 4
Views: 1672

I stand corrected

Did a simple test using my gas range. This digi cam has an IR pass filter that only sees IR -- no visible. These photos have been edited to make them easier to view. http://i663.photobucket.com/albums/uu353/MisterBaz/edited-1060209_zpsfuyfkrzf.jpg http://i663.photobucket.com/albums/uu353/MisterBaz/e...
by MrBaz
Thu Jan 26, 2017 4:46 pm
Forum: The Lounge
Topic: Infrared cameras?
Replies: 4
Views: 1672

Re: Infrared cameras?

NIR (near infrared) cameras are not going to give you temperature data. That isn't even short wave IR. Thermal is medium to long wave IR. I have both. Check thingiverse for "BazBot" where i have posted thermal images of my delta. Those images are long wave IR. I have a NIR digital camera w...
by MrBaz
Thu Jan 26, 2017 11:58 am
Forum: The Lounge
Topic: Direct Drive E3D Titan?
Replies: 5
Views: 2802

Re: Direct Drive E3D Titan?

I'm running the Titan extruder with a 0.9 degree pancake direct drive on my delta with no problems thus far. It has greatly improved my printing quality. I'll take pictures tomorrow.

It isn't aMax, but custom design. Slightly larger.
by MrBaz
Wed Dec 31, 2014 4:05 pm
Forum: New Member introduction
Topic: Bazbot
Replies: 2
Views: 775

Re: Bazbot

You have been a help so far. I've already ordered all of the 1" aluminum extrusions! They are beefy. I think that would contribute very nicely to the rigidity of the printer.
by MrBaz
Mon Dec 29, 2014 12:15 pm
Forum: New Member introduction
Topic: Bazbot
Replies: 2
Views: 775

Bazbot

I've been a lurker on the forums for quite a while. I just recently registered so I could say thanks to everyone who posted and all the information I've been able to absorb from the forums. I wanted to present my delta printer design. I've been designing this for quite some time. I started when the ...

Go to advanced search