Search found 5 matches
- Tue Nov 24, 2015 10:26 am
- Forum: FAIL HAPPENS ! ! !
- Topic: Delta arm rods broke off (disconnected) Now with Pictures
- Replies: 10
- Views: 8017
Re: Delta arm rods broke off (disconnected) Now with Picture
Hi Folks, I finally found out what happened to my printer. Or at least I did somethign which fixed it. Such a catastrophic failure had to be a combination of things. I kept trying to understand what happened and 3 more prints snapped the rods from their carriages. All about 80% print, all more or le...
- Mon Nov 02, 2015 6:40 pm
- Forum: FAIL HAPPENS ! ! !
- Topic: Delta arm rods broke off (disconnected) Now with Pictures
- Replies: 10
- Views: 8017
Re: Delta arm rods broken off (disconnected)
[img]https://lh3.googleusercontent.com/-Tl4qnbpQhmQ/VjfzQR1llAI/AAAAAAAAALI/T74q4NL1dq8/s640-Ic42/IMG_0186.JPG[/img] [img]https://lh3.googleusercontent.com/-RlcZwTCqb44/VjfzQQZZPhI/AAAAAAAAALE/xSYrkryu2Og/s640-Ic42/IMG_0187.JPG[/img] [img]https://lh3.googleusercontent.com/-3guqncz-ALc/VjfzQXkUpWI/AA...
- Mon Nov 02, 2015 2:19 pm
- Forum: FAIL HAPPENS ! ! !
- Topic: Delta arm rods broke off (disconnected) Now with Pictures
- Replies: 10
- Views: 8017
Re: Delta arm rods broken off (disconnected)
Correct, they just un snapped...
Can't imagine the force needed for this in multiple axis
Can't imagine the force needed for this in multiple axis
- Mon Nov 02, 2015 1:42 pm
- Forum: FAIL HAPPENS ! ! !
- Topic: Delta arm rods broke off (disconnected) Now with Pictures
- Replies: 10
- Views: 8017
Delta arm rods broke off (disconnected) Now with Pictures
Hi Folks, Something odd happened today. I was doing a very large print (37+ hours in draft) and this morning, when I checked how it was going, I found the extruder block hanging from 2 rods. The other 4 rods were broken off, i.e. disconnected, from the cheapskates. I suspect the mesh loom got entagl...
- Fri Dec 12, 2014 10:26 am
- Forum: Rostock MAX v2
- Topic: stepper motors are super hot!
- Replies: 50
- Views: 35606
Re: stepper motors are super hot!
Hi
I have the same problem.
Rostok Max V2 Keysan steppers
My extruder motor runs hot enough to melt the filament and until there is no traction.
I did make the changes for the MOTOR_CURRENT as recommended
Should we lower it a bit more?
Thanks
I have the same problem.
Rostok Max V2 Keysan steppers
My extruder motor runs hot enough to melt the filament and until there is no traction.
I did make the changes for the MOTOR_CURRENT as recommended
Should we lower it a bit more?
Thanks