Welcome to the SeeMeCNC Community

My wife has a Brother PE770, amazing what those things can do... Looking forward to seeing your progress. Thanks KAS... My intentions are to make the controller cheap... I will use RAMPS1.4 with Marlin firmware , two NEMA17 steppers for X-Y axis...One low cost DC motor converted to Servo Motor for ...

The software is free of cost and can be downloaded.

side by side.

Printed parts still on PEI bed surface.

Dear All, In the year 2008, My wife stressed me to make a DIY embroidery machine with bigger Hoop and that can do all type of stitch work... .. It was a challenge to me... .. All types of stitches!!!!.. I asked her What do you mean by All type of stitches???...She replied " I need a machine tha...

Gr8 idea....thanks for sharing..

Just designed the probe holder to be mounted on my new delta printer the OPTIMUS-4G

why not slice the model into pieces.. Also increase the layer Height from 0.1 to 0.2mm , this will also give u same quality but almost reduced half of the time

At last it stands-up and alive...

Here is Thingiverse Link:
http://www.thingiverse.com/thing:1177771

I designed and now 3D printing for my CNC carved wooden Racks...

The 1st time when i heated up bed i got the detachment of sheet in exact centre.. The air inside grows so that it lifted around 3mm... I just took a needle and punctured the sheet...removed all the trapped air and pressed the sheet..From that day and now on no problem...

With this cracked glass i printed more than 100 parts. Recently replaced.

Today i tested my home-made 4th generation Delta Printer i named it OPTIMUS-4G. I have been working on it for the past seven months in bits and pieces and today was the D-day. I also put a brief comparison of my 1st delta printer "DELTA-1" with "OPTIMUS-4G". [youtube]https://www....

bot wrote:It's not so much the exposed pins as it is the mis-match of voltages using the same connector. Mix the cables, meet magic smoke (and possibly even its cousin illusionary fire).

You are right .... This can be avoided by SMART TAGGING and color code... Thats all...

Guys why do you think that the "Those exposed metal pins are at lethal voltages"? Think-out-of-the box man... Have you ever seen the other endi.e. plug, if i say that the live voltage is in the plug then do you think these exposed metal pins will still be at higher voltage?

teoman wrote: Btw: has anyone purchased pei over aliexpress. I have been searching for some and a few vendors have appeared.

Unfortunately , i didnt find PEI on Aliexpress.. I got PEI from Amazon thru my friend and it is working quite well no single ABS detachment so far...

Ok, I have purchased the stuff today. I did find fairly big sheets. I paid 5 usd each for 3 sheets. 2 of them are "frosted" and one of them is clear. Each sheet will give me 2 bed coverings. How is your setup holding up? I have the big 12 x 12 inch M3 adhesive sheets and i will attach one...

Will soon share

A work done yesterday.

I needed AC power to feed to 220VAC heat bed and the DC +5, +12 and GND to feed my RAMPS1.4 and limit switches i came up a solution.
http://www.thingiverse.com/thing:1136501

I wonder what Vodka will have an effect on the performance of hot-end ?

Thanks for the valuable feedback. As i have installed the PEI sheet it will help me a lot printing without RAFT.

mhackney..please tell wether brim/RAFT is also required for printing on PEI. Or we can directly print ABS on PEI without RAFT/BRIM. Thanks