When I go to print, the head comes down then swings over to the front left and stays there and bangs on the table . I have set the Z height .
Any ideas?
Search found 4 matches
- Sat Jun 20, 2015 10:12 am
- Forum: Troubleshooting
- Topic: PRINT HEAD GOES TO THE LEFT STAYS THERE
- Replies: 0
- Views: 1363
- Tue Sep 30, 2014 11:37 pm
- Forum: Troubleshooting
- Topic: Simplify 3d temperature setting
- Replies: 2
- Views: 4314
Simplify 3d temperature setting
I am have a problem with setting the BED and Nozzle temperatures. I have set up to print PLA. No bed temp and nozzle temp @ 205. It starts out right but switches to ABS setting in just about 1 minute. 100 deg bed temp and nozzle @ 230. Can't figure out what I am doing wrong. Any suggestions would be...
- Sat Aug 30, 2014 6:24 pm
- Forum: Troubleshooting
- Topic: Tolerances
- Replies: 2
- Views: 5190
Re: Tolerances
Thanks
I thought I had posted it on the Orion Group. I am new to the group so I have feel my way around a little.
I thought I had posted it on the Orion Group. I am new to the group so I have feel my way around a little.
- Sat Aug 30, 2014 3:35 pm
- Forum: Troubleshooting
- Topic: Tolerances
- Replies: 2
- Views: 5190
Tolerances
If I make a ring the is 1" od with .8" id x .250" thick. What can to tolerances can expect? Machine is a Orion Delta