;START OF SWEEP ON TABLE FOR 
;SETTING PRINTER_RADIUS
; EERPOM NAME IS HORIZONTAL RADIUS
;
;INSTRUCTIONS:
;
;OPEN EEPROM SETTINGS, AND WRITE DOWN HORIZONTAL RADIUS VALUE
;AS WELL AS SEGMENTS/S FOR TRAVEL VALUE
;
;CHANGE SEGMENTS/S FOR TRAVEL TO MATCH SEGMENTS/S FOR PRINTING
;(EXAMPLE FROM 70 TO 180 ETC...)
;
;If your nozzle raises UP in the center of the table
; INCREASE your horizontal radius value 
;
;If your nozzle raises DOWN in the center of the table
; DECREASE your horizontal radius value
;
;After you have adjusted the value to keep the nozzle flat
;across the table, don't forget to
;go back and:
;SET SEGMENTS/S FOR TRAVEL BACK TO ORIGINAL VALUE
;(EXAMPLE WAS 70)
;
G28
G1 Z.1 F5000
G1 X-70 
G4 S2
G1 X70 F1200
G1 X-70
G1 X70 
G1 X-70
G1 X0 Y0 Z100 F5000
;END