; Calibration program for Onyx bed -Jog down from 10mm
; Its recommended you increase max length in EEPROM or COnfig.h by 1mm before running this program so you have room for adjustment downwards
; IMPORTANT!!!  Make sure after you have done this you can jog to Z3 without hitting the bed
G28
G90 G1 X0 Y0 Z20 F3000
G1 X0 Y0 Z10 F2000
@pause When stopped, jog Z down to snag paper, enter M114 into gcode window and record bed center Z location in spreadsheet, then press continue
G1 X0 Y0 Z20
G1 X-77.94 Y-45 Z20 F2000
G1 X-77.94 Y-45 Z10 F2000
@pause When stopped, jog Z down to snag paper, enter M114 into gcode window and record X Column Z location in spreadsheet, then press continue
G1 X-77.94 Y-45 Z20 F2000
G1 X77.94 Y-45 Z20 F2000
G1 X77.94 Y-45 Z10 F2000
@pause When stopped, jog Z down to snag paper, enter M114 into gcode window and record Y Column Z location in spreadsheet, then press continue
G1 X77.94 Y-45 Z20 F2000
G1 X0 Y90 Z20 F2000
G1 X0 Y90 Z10 F2000
@pause When stopped, jog Z down to snag paper, enter M114 into gcode window and record Z Column Z location in spreadsheet, then press continue
G1 X0 Y90 Z20 F2000
G1 X0 Y0 Z100 F2000
@pause When stopped, adjust limit screws as prescribed by spreadsheet, the press continue
G28