All about the retired H-1.1 3D Printers
- Posts: 13
- Joined: Sat Aug 11, 2012 12:06 pm
I assume the H1.1 could be used for milling also. If so what other hardware and software could be used for this?
- Posts: 736
- Joined: Mon Mar 26, 2012 1:07 pm
- Location: Goshen, IN
Well, you could get away with tiny cuts, go check out our youtube channel and see steve doing a monalisa portrait on acrylic
- Posts: 23
- Joined: Mon Mar 26, 2012 7:59 pm
- Location: Minneapolis, MN
How did that Mona Lisa turn out, anyway?
I was watching the stream live when it was running, but I don't recall seeing the finished run.