RepRap Official Gen6 Board Site

User avatar
mhackney
ULTIMATE 3D JEDDI
Posts: 5411
Joined: Mon Mar 26, 2012 4:15 pm
Location: MA, USA
Contact:

RepRap Official Gen6 Board Site

Postby mhackney » Fri Mar 30, 2012 12:36 pm

Here is the Gen6 wiki page on reprap.

I have one of these boards and only played around with it. My experience was positive though. I would like to build another H-1 configured with the Gen6. It is a single board that controls all 4 steppers and the hot end with thermistor feedback. It does not provide control for a heated bed like the RAMPS solutions do.

Cheers,
Michael

Sublime Layers - my blog on Musings and Experiments in 3D Printing Technology and Art

Start Here:
A Strategy for Successful (and Great) Prints

Strategies for Resolving Print Artifacts

The Eclectic Angler

Prober
Plasticator
Posts: 17
Joined: Wed Mar 28, 2012 12:01 pm

Re: RepRap Official Gen6 Board Site

Postby Prober » Sun Apr 01, 2012 7:59 pm

I does run Marlin and I have had some decent experiences with Gen6.
:P

Prober
Plasticator
Posts: 17
Joined: Wed Mar 28, 2012 12:01 pm

Re: RepRap Official Gen6 Board Site

Postby Prober » Wed May 16, 2012 12:18 am

Found a Utube video that helps understanding the firmware for a new person

http://youtu.be/7BE4xT7cqis


Return to “Gen6 and variants”

Who is online

Users browsing this forum: No registered users and 0 guests