Sanguino Build Instructions or Log?

solodude
Plasticator
Posts: 18
Joined: Sat Mar 31, 2012 9:31 pm

Sanguino Build Instructions or Log?

Postby solodude » Tue Apr 03, 2012 3:29 pm

Anyone have a good guide for wiring the H1 with a Sanguino...? or a solid build log ? Even photos?

Thanks in advance...! :)

-SD

User avatar
michaellatif
Printmaster!
Posts: 357
Joined: Mon Mar 26, 2012 1:34 pm
Location: RTP, NC

Re: Sanguino Build Instructions or Log?

Postby michaellatif » Tue Apr 03, 2012 11:29 pm

I think as long as you follow the build instructions for the board you have and use the wiring instructions for the H-1 you have enough information to get it put together.
If you are looking for what wire to what pin, there is quite a bit of information on the RepRap wiki for your board, for example Sanguinololu:
http://reprap.org/wiki/Sanguinololu

For wiring schematics:
http://reprap.org/wiki/Sanguinololu#Wiring_shematics

For H-1 electronics manual:
viewtopic.php?f=39&t=69

Then I have a thread in this forum for settings used with Repetier Host/Firmware.
viewtopic.php?f=31&t=33

Let me know if you are looking for something else.
Mike Latif
H-1 #3

solodude
Plasticator
Posts: 18
Joined: Sat Mar 31, 2012 9:31 pm

Re: Sanguino Build Instructions or Log?

Postby solodude » Sun Apr 08, 2012 3:45 am

I think I have the boot loader on my board but I need to get the firmware loaded now... I am trying to figure all this out but everything is so vague.

User avatar
mhackney
ULTIMATE 3D JEDDI
Posts: 5411
Joined: Mon Mar 26, 2012 4:15 pm
Location: MA, USA
Contact:

Re: Sanguino Build Instructions or Log?

Postby mhackney » Sun Apr 08, 2012 9:35 am

Ah, welcome to the world of open source!

Sublime Layers - my blog on Musings and Experiments in 3D Printing Technology and Art

Start Here:
A Strategy for Successful (and Great) Prints

Strategies for Resolving Print Artifacts

The Eclectic Angler

User avatar
michaellatif
Printmaster!
Posts: 357
Joined: Mon Mar 26, 2012 1:34 pm
Location: RTP, NC

Re: Sanguino Build Instructions or Log?

Postby michaellatif » Sun Apr 08, 2012 10:20 am

solodude wrote:I think I have the boot loader on my board but I need to get the firmware loaded now... I am trying to figure all this out but everything is so vague.


What board are you using and what firmware?
Mike Latif
H-1 #3


Return to “Sanguino (lulu etc...)”

Who is online

Users browsing this forum: No registered users and 0 guests