Selling my heated cabinet

Discussions related to the Rostock MAX v2
Post Reply
User avatar
Stevolution
Printmaster!
Posts: 195
Joined: Tue Jan 13, 2015 5:11 pm

Selling my heated cabinet

Post by Stevolution » Sun Aug 11, 2019 1:26 pm

Not sure if this is the right place to put this? It is Max V2 related!

Don't ever use my Max V2 now, so the cabinet is just sitting there unused.

It is madly over-engineered.

It has a pair of plug-in heated panels that heat the cabinet very well.
The top half of the cabinet is separate to the base cupboard for ease of moving it. The top lifts off so that you can install your V2.
RGB LEDs up each internal corner.

Now inside is a wealth of complicated Arduino stuff that run the small TFT screen on the front, and the LEDS etc. The 2560p Arduino also runs the heater elements using a temp sensor inside the cabinet.

It never really worked 100% correctly, and I never bothered to fix it as the cabinet heats up, and that is all you really need.
I used to just set the leds to white.

The RGB leds were configured to change colour as the temp changed, but I turned that feature off.

There is also a weighing feature, as the top of my Max V2 has a custom spool holder that incorporates a load cell. Gives me a reading of the remaining spool weight.

But.... unless you want my now defunked Max V2, then that feature would not work.

Best bet? Buy it as a base cabinet and fill it with your own controls. The front control panel comes out easy enough.
There is a central ducted fan that keeps the base of the V2 cool when in use.

Instructions are attached, but inside my V2 is another processor that works with the Mega2560p... so its not just drop your Max V2 in and go.
Also, the RGB driver board is inside my V2.

I think the best option is I strip it out, leave the heaters and RGB leds and you retro-fit the empty case as you see fit to your spec.

Hmm... anyone? Cost a pile of pennies and time to make, but no idea what it is worth.
Attachments
20160721_163242.jpg
20160713_235143.jpg
20160713_234905_001.jpg
20160713_234850.jpg
20160712_112804.jpg
20160712_112751.jpg
20160712_111757.jpg
20160711_142523.jpg
20160624_133153.jpg
20160624_132819.jpg
Last edited by Stevolution on Sun Aug 11, 2019 1:29 pm, edited 2 times in total.

User avatar
Stevolution
Printmaster!
Posts: 195
Joined: Tue Jan 13, 2015 5:11 pm

Re: Selling my heated cabinet

Post by Stevolution » Sun Aug 18, 2019 2:08 pm

Too late

Stripped the Max V2 for its parts to make a CNC (I have a far more reliable 3d printers now).
Stripped out the cabinet and burnt it.

Bye bye rubbish Max V2 :roll:

User avatar
geneb
ULTIMATE 3D JEDDI
Posts: 4954
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Selling my heated cabinet

Post by geneb » Mon Aug 19, 2019 8:21 am

Considering the thousands of well working v2s there are out there, maybe the printer isn't the failure point here. ;)

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects

Post Reply

Return to “Rostock MAX v2”