An affordable delta DIY kit made with high quality electronics/parts/hardware
2 posts • Page 1 of 1
When I printed the test tower above, the numbers came out mirror imaged. IS this due to a problem building the printer?
At one point, I was told to connect the XY, XY, and Z stepper motor wires to the X,Y, and Z sockets on the motherboard.
I took a guess at which XY was X and which was Y. If this was wrong, would that cause the mirror imaging?
Swap the X and Y motor connections, also swap the X and Y endstop switch connections assuming the printer homes correctly at present. If you are using software endstop position corrections then you will need to swap those X and Y values too.
Who is online
Users browsing this forum: No registered users and 0 guests