Problem getting extruder to run

Having a problem? Post it here and someone will be along shortly to help
Gwarden
Noob
Posts: 1
Joined: Fri May 18, 2018 11:02 am

Problem getting extruder to run

Postby Gwarden » Tue Sep 11, 2018 1:50 pm

I experienced some problems with my Rostock V2 when I blew a fuse. I replaced it and I had problems with the hotend getting plugged, then the extruder stopped working. I ordered a new extruder motor and it still does not work. I note my board has a yellow set of LED flashing
Marked T and X
The 3 stepper motors on the X Y and Z axis are working as are the fans.

Any help??
Thnx
Dennis

Return to “Troubleshooting”

Who is online

Users browsing this forum: No registered users and 5 guests