Right now I am trying to print a thin object that is too big in two dimensions to lay flat, in fact it is too big to lay on any of its surfaces, so the only way I can get it within the build envelope is to tip it up onto a very short edge.
As currently arranged in Cura it is 10 mm x 241.9 mm x 306.8 mm (1532 layers) and it is "balancing" on that 10 mm edge.
My problem seems to be to get all the needed support material to stick - support material seems to be deliberately "fragile" so that it will breakaway, I can understand that, but I would like to get it to adhere WELL to the glass.
Any hints, tips for settings to get this to happen would be appreciated.
The one, the only, the Atremis. Forum for the monster metal machine from SeeMeCNC
2 posts • Page 1 of 1
The description for "Enable support floor" suggests that this would put down a more solid foundation on the glass, however looking at the first few layers doesn't show any difference - also the print time and amount of filament used don't change, so I doubt that this actually does anything.
Who is online
Users browsing this forum: No registered users and 0 guests