Very New, very green

Introduce yourself to the community!
Posts: 7
Joined: Thu May 03, 2018 1:15 pm

Very New, very green

Postby Vulchikova » Tue Jun 05, 2018 2:36 pm

Greetings all,

I have never owned or printed with any 3D printer before, though oddly enough I was involved in the design of FormLabs 1. I work with robotics fairly frequently and have been wanting a printer for quite some time so I can make some custom parts. After several months of research, reading reviews, reading here, and facebook posts, I finally purchased a Rostock Max 3.2.

My son and I built it together and took our time. I would say total build time was about 16+ hours. We ran into a couple glitches and frustrations, but worked through them. Yesterday the build was complete and I printed the little steam boat. Damn near flawless! Resolution was higher than I expected for a demo print. There was a little stringing, but that is trivial.

Now I have to print the Due case. Will start that tonight.

User avatar
Posts: 1495
Joined: Wed Sep 23, 2015 2:55 pm

Re: Very New, very green

Postby Xenocrates » Thu Jun 07, 2018 10:59 am

Welcome to the forums. As someone else who works with robotics, what sort of systems and parts do you work with? I think you'll be very happy with the V3.2 in the long term.
Rostock Max V2, 760W corsair modular PSU, PT100 enabled E3D V6 and volcano, self adjusting carriages, Raymond style enclosure
Automation Technology 60W laser cutter/engraver

Sic Transit Gloria Mundi

Return to “New Member introduction”

Who is online

Users browsing this forum: No registered users and 1 guest