im taking the H2 into my classroom for the students to learn basics...
however, since i use cura to slice (and go wireless to my artemis duet board...)
id like to also use wireless to go from cura to my H2, ..
can someone point me to a good tutorial or video or other to setup the 'octoprint on a rasberry board and config it?
i'd like to see what and where to get the boards/parts, and where to d/load and install/config the software for it.
An affordable delta DIY kit made with high quality electronics/parts/hardware
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests