Vat designs and coatings etc..., Electronics and mods, Z stages and mechanisms to release the prints from Vats etc...
1 post • Page 1 of 1
I looked at the store page and it says they're all sold out. Is SeeMeCNC still going to sell these, and if so, when will more be available?
AI Calibration | Dimensional Accuracy Calibration | Hand-Tune your PID | OctoPi + Touchscreen setup | My E3D hot end mount, Z probe, fan ducts, LED ring mount, filament spool holder, etc.
Who is online
Users browsing this forum: No registered users and 0 guests