I R DONE!!!!!1

All about the retired, first generation H-1 3D printers
jbinion
Printmaster!
Posts: 84
Joined: Mon Jun 04, 2012 11:46 am

I R DONE!!!!!1

Postby jbinion » Fri Jul 20, 2012 9:45 pm

Well not really but petty close. Still need to wire up the controller and pretty much every thing else. I have two LED thermostats from ebay. One for the heated bed, the other I hope to be able to use the thermocoupler and the led readout to measure the temp on the hot end. The first picture is of the plexiglas box we made for the electronics and the two blue cooling fans.
208900_473364029340534_331664633_n.jpg
Ellen's box and blue cooling fans

600106_477822588894678_1935311161_n.jpg
Front view.

376646_477822205561383_947611366_n.jpg
View from the top

394727_477822082228062_95419555_n.jpg
Position LED and Velleman Thermostat

jbinion
Printmaster!
Posts: 84
Joined: Mon Jun 04, 2012 11:46 am

Re: I R DONE!!!!!1

Postby jbinion » Fri Jul 20, 2012 9:49 pm

We put the box together so we can take the printer off and use the controller system for a CNC if we wanted to.

tom10122
Printmaster!
Posts: 401
Joined: Fri May 11, 2012 11:18 pm
Location: NJ

Re: I R DONE!!!!!1

Postby tom10122 » Thu Jul 26, 2012 9:43 am

Nice enclosure , Is there a way for the air to circulate though?

jbinion
Printmaster!
Posts: 84
Joined: Mon Jun 04, 2012 11:46 am

Re: I R DONE!!!!!1

Postby jbinion » Thu Jul 26, 2012 9:13 pm

We have a large fan on the top pulling air out to the bottom of the table and one in the front to push air into the enclosure. So far it seems to be keeping everything cool.

tom10122
Printmaster!
Posts: 401
Joined: Fri May 11, 2012 11:18 pm
Location: NJ

Re: I R DONE!!!!!1

Postby tom10122 » Fri Jul 27, 2012 7:21 pm

Ok Just wondering


Return to “H-1 3D Printers”

Who is online

Users browsing this forum: No registered users and 0 guests