Discontinued???

The ERIS Delta, a truly affordable entry into Delta 3D Printing
Mac The Knife
ULTIMATE 3D JEDDI
Posts: 1306
Joined: Sun May 11, 2014 6:18 pm

Discontinued???

Postby Mac The Knife » Mon Feb 05, 2018 12:14 pm

While showing a coworker the SeeMeCNC webstore, I was surprised to see that the Eris has been discontinued. It had some teething pains at first, but I didn't figure it to be that much of a problem child.

After I installed springs on the arms to take up the lash, and re adjusted settings in the firmware for the calibration rates, it has been printing pretty satisfactorily for me.
R-Max V2
Eris

Return to “ERIS Delta”

Who is online

Users browsing this forum: No registered users and 1 guest