The ERIS Delta, a truly affordable entry into Delta 3D Printing
2 posts • Page 1 of 1
I am enclosing a photo of a print that dies a mysterious death. It started just fine, good adhesion. It was doing fine for over an hour so I worked in another part of my home for a few hours and came back to this. This has happened consistently for the last few times I have tried to print. It looks like the temperature may be changing or something back and forth. You can see lots of bad sections then some good ones. Any insight as to what is going wrong and what I can do to fix it? Thanks much.
Who is online
Users browsing this forum: No registered users and 2 guests