Page 1 of 1
Posted: Sat Aug 30, 2014 3:35 pm
If I make a ring the is 1" od with .8" id x .250" thick. What can to tolerances can expect? Machine is a Orion Delta
Posted: Sat Aug 30, 2014 5:38 pm
I can't speak directly about the Orion (yet) but with FFF machines I typically keep a tolerance of about 200 to 400 micron. It might be better to post the question in the Orion section though.
Posted: Sat Aug 30, 2014 6:24 pm
I thought I had posted it on the Orion Group. I am new to the group so I have feel my way around a little.