So I purchased this from SeeMeCNC and got it in the mail:
http://www.seemecnc.com/products/univer ... n-printers
but I have no idea how it attach it to the Droplit.
It seems way to big for the droplit base....
Thanks is advanced again!!!
Vat designs and coatings etc..., Electronics and mods, Z stages and mechanisms to release the prints from Vats etc...
2 posts • Page 1 of 1
- ULTIMATE 3D JEDDI
- Posts: 2631
- Joined: Sun Mar 31, 2013 1:35 am
- Location: Notre Dame area
You might want to drop them a support email, I'm not sure if anyone's trailblazed this yet. I use a variation of their flex-vat on my Little-RP that I printed myself and custom cut the FEP for, and I know that their vat fits the DropLit-2, but I'm not sure about the V1.
Who is online
Users browsing this forum: No registered users and 1 guest