Vat designs and coatings etc..., Electronics and mods, Z stages and mechanisms to release the prints from Vats etc...
5 posts • Page 1 of 1
Hi Guys, just finished the droplit build and I'm having problems connecting. I'm pretty sure I got it configured right but get invalid printer response in the connect window of Mattercontrol. When I hit connect, the whining from the motor pauses while the connection is attempted, then resumes after failing. The motor spindle is also locked up. Any Ideas ?
Ok so I can upload stepper speed control from arduino 1.6.7 and the led on the board starts flashing with simultaneous whining from the motor, but no rotation. I know I wired it up correctly so it makes me think of a defective motor ? maybe
Who is online
Users browsing this forum: No registered users and 2 guests