Vat designs and coatings etc..., Electronics and mods, Z stages and mechanisms to release the prints from Vats etc...
1 post • Page 1 of 1
Do any folks running the DropLit have a permanent, or at least secure, mount for the projector? It is quite annoying to have to recenter, refocus, recalibrate, etc. when something bumps the projector out of alignment. It would be nice to have confidence everything is still the way it last printed correctly. I'm using the Acer P1500 which sits nicely on the platform but is blocked up all around and higher in back.
Who is online
Users browsing this forum: No registered users and 1 guest