firmware and cw correct setting needed

Vat designs and coatings etc..., Electronics and mods, Z stages and mechanisms to release the prints from Vats etc...
michaels
Plasticator
Posts: 8
Joined: Sun Mar 03, 2013 11:54 pm
Location: Connecticut

firmware and cw correct setting needed

Postby michaels » Wed Sep 07, 2016 8:40 pm

I had my company buy the droplit printer. It sat on a shelf for over one year before I was asked to help them out. I have the printer together and projector all set.
I am unable to find the firmware needed and with CW I am unable to locate setting.

Any help would be great.

mike

User avatar
KAS
ULTIMATE 3D JEDDI
Posts: 1157
Joined: Thu Dec 04, 2014 6:06 pm

Re: firmware and cw correct setting needed

Postby KAS » Wed Sep 07, 2016 8:50 pm

See if this will help you: https://github.com/seemecnc

User avatar
Jimustanguitar
ULTIMATE 3D JEDDI
Posts: 2631
Joined: Sun Mar 31, 2013 1:35 am
Location: Notre Dame area
Contact:

Re: firmware and cw correct setting needed

Postby Jimustanguitar » Thu Sep 08, 2016 8:17 am

You might want to give JJ and the support team a shout. I'm not sure what their "stock" program is now. Creation Workshop went closed source last year, so the documentation and support for it are non existent now. I still use an old version of it, as do many others, but I've got a different machine with a simpler Arduino setup. I think the DropLit uses a Rambo mini, right?

All the cool kids are switching to Raspberry Pi control with a program called NanoDLP. http://www.nanodlp.com/

michaels
Plasticator
Posts: 8
Joined: Sun Mar 03, 2013 11:54 pm
Location: Connecticut

Re: firmware and cw correct setting needed

Postby michaels » Thu Sep 08, 2016 6:54 pm

Thanks will look on github


Return to “DropLit”

Who is online

Users browsing this forum: No registered users and 2 guests