2 posts • Page 1 of 1
I have been using MatterControl for a while now and although the layer fan is controllable from the "Controls" section of the program, once a print that should be using the fan begins, it never turns on. Which setting should enable the layer fan for different materials? I have tried min fan speed, max fan speed, and bridge fan speed and none seem to do what I want.
I do not use mattercontrol, but there is likely a checkbox that enables/disables the layer fan completely without altering the speeds. Look for this checkbox.
If at first you don't succeed, you're doing something wrong. Try again, and if it fails again, try once more. Through trial and error, one can be the first to accomplish something great.
Who is online
Users browsing this forum: No registered users and 2 guests